Solaris9 sparc下4050HBA卡的安装
一、 组网需求:
无
二、 组网图:
无
三、 配置步骤:
一.安装驱动
1.将安装文件“qla4xxx.sparc.Z”拷贝到/tmp目录下,并进入该目录
2.# uncompress qla4xxx.sparc.Z /解压该安装包
3.# pkgadd -d qla4xxx.sparc /安装该文件
4.开始安装对话,一路按Enter继续,直到出现下面这句时,选择y
Do you want to continue with the installation of <QLA4xxx-0> [y,n,?] y
5.出现下面这句话,表示安装已完成
Installation of <QLA4xxx-0> was successful.
二.安装SANsurfer界面工具
1.将安装文件“iSCSI_SANsurfer_4_02_22_solarisSparc_package.tgz”拷贝到/tmp目录下,并进入该目录
2.# gunzip iSCSI_SANsurfer_4_02_22_solarisSparc_package.tgz
/解压该安装包
3.# tar xvf iSCSI_SANsurfer_4_02_22_solarisSparc_package.tar
/解压该安装包
4.# sh iSCSI_SANsurfer_4_02_22_solarisSparc.bin
/安装该文件
5.看到下面一段话后,说明已启动图形安装界面,按提示进行安装,缺省安装在/opt目录下。
Preparing to install...
Extracting the JRE from the installer archive...
Unpacking the JRE...
Extracting the installation resources from the installer archive...
Configuring the installer for this system's environment...
Launching installer...
6.reboot -- -r /重启系统,使其生效
(注意:必需严格使用此命令格式,否则无法生效)
四、 配置关键点:
此文档中红色部份为文件名,仅供参考
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作