SR66和Cisco三层聚合配置

SR66和Cisco三层聚合配置

SR66和Cisco 6509做链路聚合，需要注意的事，Cisco的物理口和port-channel口需要no shutdown后才能使用；

静态聚合和动态聚合两种模式下的配置如下所示：

静态模式的链路聚合

SR66的版本和配置：

[SR6602]display version

H3C Comware Platform Software

Comware Software, Version 5.20, Release 2420P04

Copyright (c) 2004-2010 Hangzhou H3C Tech. Co., Ltd. All rights reserved.

H3C SR6602 uptime is 0 week, 0 day, 0 hour, 17 minutes

配置：

interface GigabitEthernet0/0

combo enable fiber

port link-aggregation group 1

#

interface GigabitEthernet0/1

combo enable fiber

port link-aggregation group 1

#

interface Route-Aggregation1

ip address 192.168.11.1 255.255.255.252

#

[SR6602]display link-aggregation verbose

Aggregation Interface: Route-Aggregation1

Aggregation Mode: Static

Loadsharing Type: Share

Port Status Oper-Key

------------------------------------------------------------------------------

GE0/0 S 1

GE0/1 S 1

[SR6602]

Cisco的版本和配置：

=============

Router#show version

Cisco Internetwork Operating System Software

IOS (tm) c6sup2_rp Software (c6sup2_rp-PS-M), Version 12.2(18)SXD4, RELEASE SOFT

WARE (fc1)

ROM: System Bootstrap, Version 12.1(4r)E, RELEASE SOFTWARE (fc1)

BOOTLDR: c6sup2_rp Software (c6sup2_rp-PS-M), Version 12.2(18)SXD4, RELEASE SOFT

WARE (fc1)

Cisco WS-C6509 (R7000) processor (revision 3.0) with 112640K/18432K bytes of mem

ory.

Processor board ID SAL0807UDH9

R7000 CPU at 300Mhz, Implementation 0x27, Rev 2.1, 256KB L2, 1024KB L3 Cache

Last reset from power-on

X.25 software, Version 3.0.0.

Bridging software.

配置：

interface Port-channel1

ip address 192.168.11.2 255.255.255.252

!

interface GigabitEthernet5/1

no ip address

channel-group 1 mode on

!

interface GigabitEthernet5/2

no ip address

channel-group 1 mode on

!

Router#show interfaces port-channel 1 etherchannel

Ports in the Port-channel:

Index Load Port EC state No of bits

------+------+------+------------------+-----------

0 55 Gi5/1 On/FEC 4

1 AA Gi5/2 On/FEC 4

Time since last port bundled: 0d:00h:06m:13s Gi5/2

动态聚合

SR6602 dynamic的配置：

#

interface Route-Aggregation1

link-aggregation mode dynamic

ip address 192.168.11.1 255.255.255.252

#

interface GigabitEthernet0/0

combo enable fiber

port link-aggregation group 1

#

interface GigabitEthernet0/1

combo enable fiber

port link-aggregation group 1

Cisco dynamic:

===============

Router#show running inter port-channel 1

!

interface Port-channel1

ip address 192.168.11.2 255.255.255.252

end

!

interface GigabitEthernet5/1

no ip address

channel-group 1 mode active

end

!

interface GigabitEthernet5/2

no ip address

channel-group 1 mode active

end

在上述两种模式，两端都可以互相ping通，且ARP学习正常：

====================================

[SR6602]ping 192.168.11.2

PING 192.168.11.2: 56 data bytes, press CTRL_C to break

Reply from 192.168.11.2: bytes=56 Sequence=1 ttl=255 time=2 ms

Reply from 192.168.11.2: bytes=56 Sequence=2 ttl=255 time=1 ms

Reply from 192.168.11.2: bytes=56 Sequence=3 ttl=255 time=1 ms

Reply from 192.168.11.2: bytes=56 Sequence=4 ttl=255 time=1 ms

Reply from 192.168.11.2: bytes=56 Sequence=5 ttl=255 time=1 ms

--- 192.168.11.2 ping statistics ---

5 packet(s) transmitted

5 packet(s) received

0.00% packet loss

round-trip min/avg/max = 1/1/2 ms

[SR6602]display arp all

Type: S-Static D-Dynamic A-Authorized

IP Address MAC Address VLAN ID Interface Aging Type

192.168.11.2 000e-d6f7-ec0a N/A RAGG1 20 D

[SR6602]

Router#ping 192.168.11.01

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.11.1, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms

Router#show arp

Protocol Address Age (min) Hardware Addr Type Interface

Internet 192.168.11.2 - 000e.d6f7.ec0a ARPA Port-channel1

Internet 192.168.11.1 0 0002.0001.0001 ARPA Port-channel1

Router#