现场一台S5560X对接S12500设备,S5560X版本为R1119P12,组网如图:
1. 现场反馈该5560X设备和125X设备动态链路聚合异常:
5560X上:
interface Bridge-Aggregation1
port access vlan 1006
link-aggregation mode dynamic
undo stp enable
Aggregate Interface: Bridge-Aggregation1
Local:
Port Status Priority Index Oper-Key Flag
XGE1/0/25(R) S 32768 1 1 {ACDEFG}
XGE1/0/26 U 32768 2 1 {ACG}
Remote:
Actor Priority Index Oper-Key SystemID Flag
XGE1/0/25 32768 0 0 0x8000, 0000-0000-0000 {DEF}
XGE1/0/26 32768 0 0 0x8000, 0000-0000-0000 {DEF}
125X上:
interface Bridge-Aggregation407
port access vlan 2000
link-aggregation mode dynamic
undo stp enable
Aggregate Interface: Bridge-Aggregation407
Creation Mode: Manual
Aggregation Mode: Dynamic
Loadsharing Type: Shar
Management VLANs: None
System ID: 0x8000, 5098-b8d2-4800
Local:
Port Status Priority Index Oper-Key Flag
XGE1/4/0/7 U 32768 31 25 {ACD}
XGE3/4/0/7 U 32768 43 25 {ACD}
Remote:
Actor Priority Index Oper-Key SystemID Flag
XGE1/4/0/7 32768 1 1 0x8000, 441a-facc-e440 {ACEFG}
XGE3/4/0/7 32768 2 1 0x8000, 441a-facc-e440 {ACG}
2、改为静态链路聚合可以正常选中,且业务报文交互正常:
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Static
Loadsharing Type: Shar
Management VLANs: None
Port Status Priority Oper-Key
XGE1/0/25(R) S 32768 1
XGE1/0/26 S 32768 1
(1)
[EOR-1-probe]ping 1.1.1.3
Ping 1.1.1.3 (1.1.1.3): 56 data bytes, press CTRL_C to break
*Jan 19 06:59:56:659 2011 EOR-1 DRVPLAT/7/RxTxDebug:
From board 1: transmit packet from chip0,port5,Priority=3,len=102
-----------------------------------------------------
0000 70 57 bf 30 10 f9 7c 1e 06 2c 1f 9a 81 00 00 c8
0010 08 00 45 00 00 54 fc 50 00 00 ff 01 bb 52 01 01
0020 01 01 01 01 01 03 08 00 01 17 25 dc 00 00 4d 36
0030 8b ec 00 0a 0c dd 08 09 0a 0b 0c 0d 0e 0f 10 11
-----------------------------------------------------
56 bytes from 1.1.1.3: icmp_seq=0 ttl=255 time=133.296 ms
56 bytes from 1.1.1.3: icmp_seq=1 ttl=255 time=2.477 ms
*Jan 19 06:59:56:993 2011 EOR-1 DRVPLAT/7/RxTxDebug:
From board 1: transmit packet from chip0,port5,Priority=3,len=102
-----------------------------------------------------
0000 70 57 bf 30 10 f9 7c 1e 06 2c 1f 9a 81 00 00 c8
0010 08 00 45 00 00 54 fc 51 00 00 ff 01 bb 51 01 01
0020 01 01 01 01 01 03 08 00 e8 7b 25 dc 00 01 4d 36
0030 8b ec 00 0f 25 72 08 09 0a 0b 0c 0d 0e 0f 10 11
-----------------------------------------------------
(2)
<SW-L2B-SURV-AS01>dis lldp neighbor-information list
There is no neighbor on the device.
但在125X上可以正常看到邻居:
XGE1/4/0/7 441a-facc-e440 Ten-GigabitEthernet1/0/25 SW-L2B-SURV-AS01
XGE3/4/0/7 441a-facc-e440 Ten-GigabitEthernet1/0/26 SW-L2B-SURV-AS01s
(3)
[SW-L2B-SURV-AS01-probe]debug qacl show sl 1 c 0 v 0 acl-type 8
========
Acl-Type RX IPv4 High, Stage IPCL 2, Global, ToInstall, Active
Prio Mjr/Sub 0x30b/0x11, RuleFormat INGRESS_EXT_NOT_IPV6, Vtcame/Idx 4/55,
Rule Match --------
Global range
Dest mac: 0180-C200-0003, FFFF-FFFF-FFFF
EtherType: 0x88cc, 0xffff
SysmRule Index : 53
Actions --------
Account mode packets, green and non-green
Redirect : Trap to cpu
Change CPU pkt COS 5
Red Deny
Red_Copy_to_cpu : No
Yel Deny
Yel_Copy_to_cpu : No
MatchedName:53, LLDP
Skip the following PCL lookups
Skip the following ingress pipe
Skip the Bridge
Accounting: Hi 0, Lo 0
(4)
[SW-L2B-SURV-AS01-Ten-GigabitEthernet1/0/25]qos apply policy LLDP inbound
[SW-L2B-SURV-AS01-Ten-GigabitEthernet1/0/25]%Mar 9 15:33:14:476 2020 SW-L2B-SURV-AS01 QOS/4/QOS_POLICY_APPLYIF_CBFAIL: Failed to apply classifier-behavior LLDP in policy LLDP to the inbound direction of interface Ten-GigabitEthernet1/0/25. Operation failed.
(5)
问题单号 |
简述 |
基线版本-子版本 |
【S5560X B70D022SP维护分支】【同步问题单:201906110314】【端口专项】端口下发满规格acl提示失败,实际底层已下发,但打流不生效 |
S5560XV100R001B01D047 |
(6)
(1)
(2)
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作