Print

某局点 S6800-32Q qmprofile无法配置问题

2天前 发表

组网及说明

不涉及

问题描述

现场配置qmprofile时报错,提示如下:

[DSYY-8-3F-S6800-CORE-qmprofile-qos]queue  be  wrr  group 1 byte-count  4

The scheduling units must be the same.

过程分析

实验室测试也是一样的报错,后经确认, 当队列已配置为WRR或WFQ方式时,如需修改其调度权重的单位(weight或byte-count),必须先将所有非SP队列均配置为SP,再配置队列的调度方式及调度权重单位为所需的配置:

 [S6800-54QT-2.10-qmprofile-qos]queue 1 sp
[S6800-54QT-2.10-qmprofile-qos]queue 2 sp
[S6800-54QT-2.10-qmprofile-qos]queue 3 sp
[S6800-54QT-2.10-qmprofile-qos]queue 4 sp
[S6800-54QT-2.10-qmprofile-qos]queue 5 sp
[S6800-54QT-2.10-qmprofile-qos]queue 6 sp
[S6800-54QT-2.10-qmprofile-qos]queue 7 sp
[S6800-54QT-2.10-qmprofile-qos]queue be wrr group 1 byte-count 1


  [S6800-54QT-2.10]display qos qmprofile configuration qos
Queue management profile: qos (ID 1)
 Queue ID  Type  Group   Schedule   Schedule  Min         Max
                         unit       value     bandwidth   bandwidth
 ---------------------------------------------------------------------
 be        WRR   1       weight     1         N/A         N/A
 af1       WRR   1       weight     2         N/A         N/A
 af2       WRR   1       weight     3         N/A         N/A
 af3       WRR   1       weight     4         N/A         N/A
 af4       WRR   1       weight     5         N/A         N/A
 ef        WRR   1       weight     9         N/A         N/A
 cs6       WRR   1       weight     13        N/A         N/A
 cs7       WRR   1       weight     15        N/A         N/A  

  

解决方法

先将所有非SP队列均配置为SP,再配置队列的调度方式及调度权重单位为所需的配置