S6800

1、检查本端和对端聚合组的类型是否一致。

2、检查本端和对端聚合组的配置是否一致。

3、检查本端和对端聚合组和物理成员端口的配置是否一致。

4、检查本端和对端物理成员端口的双工模式、速率是否一致。

5、尝试两边都使用静态聚合看下。

6、以下是聚合组配置的参考命令：

[SW1]int Bridge-Aggregation 1   //创建链路聚合组1

[SW1-Bridge-Aggregation1]quit

[SW1]int range gi 1/0/1 to gi 1/0/2

[SW1-if-range]port link-aggregation group 1  //将链路聚合组应用到接口

[SW1-if-range]quit

[SW1]int Bridge-Aggregation 1  //继续配置链路聚合组1

[SW1-Bridge-Aggregation1]port link-type trunk

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]undo port trunk permit vlan 1

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]port trunk permit vlan 10

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]quit