WA6320S-C无线AP已经更改到FATAP模式，是否具备桥接功能？

1. 配置Mesh Profile
<AP> system-view
[AP] wlan mesh-profile 1
[AP-wlan-mesh-profile-1] mesh-id H3C-BRIDGE # 两端AP需配置相同Mesh ID
[AP-wlan-mesh-profile-1] akm mode sae # 使用SAE认证
[AP-wlan-mesh-profile-1] preshared-key pass-phrase simple 12345678 # 配置预共享密钥
[AP-wlan-mesh-profile-1] mesh-profile enable # 启用Profile
[AP-wlan-mesh-profile-1] quit
2. 配置射频接口
[AP] interface wlan-radio 1/0/1
[AP-WLAN-Radio1/0/1] type dot11ax # 指定802.11ax模式
[AP-WLAN-Radio1/0/1] channel 149 # 固定信道（需两端一致）
[AP-WLAN-Radio1/0/1] mesh-profile 1 # 绑定Mesh Profile
[AP-WLAN-Radio1/0/1] mesh peer-mac-address xxxx-xxxx-xxxx # 对端AP的射频MAC地址
[AP-WLAN-Radio1/0/1] undo shutdown # 开启射频
[AP-WLAN-Radio1/0/1] quit
3. VLAN及接口配置
# 创建业务VLAN并配置接口
[AP] vlan 100
[AP-vlan100] quit
[AP] interface vlan-interface 100
[AP-Vlan-interface100] ip address 192.168.1.1 24 # 配置管理IP
[AP-Vlan-interface100] quit

# 将物理端口加入VLAN
[AP] interface GigabitEthernet 1/0/1
[AP-GigabitEthernet1/0/1] port access vlan 100
[AP-GigabitEthernet1/0/1] quit
4. 静态路由（可选）
[AP] ip route-static 192.168.2.0 255.255.255.0 192.168.1.2 # 指向对端子网