CentOS version
Switch model and version
1.In this case,I congfigure irf between the two switches.(You can refer to the configuration guide on official website or you can skip this if you have only one switches).
2.congfigure link-aggregation.
[sw1]int bridge-aggregation 1
[sw1-bridge-aggregation1]link-aggregation mode dynamic
[sw1]int ten 1/0/25
[sw1-ten-gigabitethernet1/0/25]port link-a group 1
[sw1]int ten 2/0/25
[sw1-ten-gigabitethernet2/0/25]port link-a group 1
3.configure team in CentOS
3.1 check current device in the CentOS
3.2.create team0
[root@localhost tx]nmcli connection add type team con-name team0 ifname team0 config “{“runner”:{“name”:”lacp”}}”
3.3 configure ip and gateway for team0
3.4 add interface to team0
1.check team0 configuration file
2.check active device
3.check port status on switch.All ports are selected to the bridge-aggreation.
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作