1. 配置需求或说明
1.1 适用产品系列
本案例适用于如:HP 5406 zl Switch、HP 5412 zl Switch、
Aruba 5406R zl2 Switch、Aruba 5412R zl2 Switch等系列的交换机。
1.2 说明
交换机A作为主交换机,B作为备用交换机。
仅主接口为一组VLAN(受保护的VLAN组)转发流量。
该受保护组的另一个接口处于待机模式。 如果端口1断开,则端口2启动转发此受保护的VLAN组的流量。
2. 配置步骤
2.1 主链路配置方法
#进入全局模式
ProCurve# config
#将VLAN 1-VLAN 10映射smart组1
ProCurve(config)# vlans 1-10 mapped to smart link group 1
#配置主端口a1,备用端口a2
ProCurve(config)# smart link group 1 master a1 slave a2
#将VLAN 1-10配置为smart组1的受保护成员
ProCurve(config)# smart link group 1 protected-vlans 1-10
#分配VLAN 1发送心跳包
ProCurve(config)# smart link group 1 send-control-vlan 1
#配置延迟抢占10秒钟
ProCurve(config)# smart link group 1 preemption-mode role
ProCurve(config)# smart link group 1 preemption-delay 10
2.2 备链路配置方法
#进入全局模式
ProCurve# config
#将VLAN 11-VLAN 20映射smart组2
ProCurve(config)# vlans 11-20 mapped to smart link group 2
#配置主端口2,备用端口1
ProCurve(config)# smart link group 2 master a2 slave a1
#将VLAN 11-20配置为smart组2的受保护成员
ProCurve(config)# smart link group 2 protected-vlans11-20
#分配VLAN 10发送心跳包
ProCurve(config)# smart link group 2 send-control-vlan 11
#配置延迟抢占10秒钟
ProCurve(config)# smart link group 2 preemption-mode role
ProCurve(config)# smart link group 2 preemption-delay 15
3. 保存配置
ProCurve(config)# write memory
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作