某局点RBM切换失败（track导致）

暂不涉及

客户进行业务切换测试：

首先FW1为主墙，通过shutdown主墙的track接口 XG6/1/8，虽然对应的track状态变成了 Negative， 但是rbm的业务主备状态没有变化

Track ID: 5

State: Negative

Duration: 0 days 0 hours 0 minutes 16 seconds

Tracked object type: Interface

Notification delay: Positive 0, Negative 0 (in seconds)

Tracked object:

    Interface: Ten-GigabitEthernet6/1/8

    Protocol: None

但是RBM的状态为：

Remote backup group information:

Backup mode: Active/standby

Device management role: Primary

Device running status: Active

Data channel interface: Route-Aggregation1

Local IP: 1.1.1.1

Remote IP: 1.1.1.2

Destination port: 60064

Control channel status: Connected

Keepalive interval: 1s

Keepalive count: 10

Configuration consistency check interval: 24 hour

Configuration consistency check result: Inconsistent(2022-01-26 12:11:44)

Configuration backup status: Auto sync enabled

Session backup status: Hot backup enabled

Delay-time: 30 min

经过分析发现，原来是FW2上也存在很多track项，并且由于误操作导致其中一个track项的接口down掉了（并不是对应FW1的track5）

Track ID: 2

State: Negative

Duration: 80 days 0 hours 49 minutes 9 seconds

Tracked object type: Interface

Notification delay: Positive 0, Negative 0 (in seconds)

Tracked object:

Interface: Ten-GigabitEthernet6/1/6

Protocol: None

由于RBM的切换机制也是依靠权重来实现，FW1和FW2目前各down掉一个接口，权重保持不变，所以不会进行切换

把FW2的异常端口track删除后，经过测试可以正常切换