H3C设备和华为设备通过支持Flex-E的接口进行对接,并在该接口上划分Flex-E切片,实现Flex-E切片接口互通。
一、配置H3C设备
1、将物理接口从普通以太接口切换成Flex-E接口
[H3C]int HundredGig2/1/2
[H3C- HundredGig2/1/2 ]port-type flexe
The interface HundredGig2/1/2 will be deleted. Continue? [Y/N]:y
Switching interface type. Please wait...
2、配置Flex-E Group,绑定Flex-E接口,并划分Flex-E切片接口。其中Group ID为305021,phy-number为1,划分3个切片,client ID分别为1、2、3,带宽分配为70、10、20.
#
interface FlexE-Group2/1/305021
description Link-to-HW
bind interface FlexE-HundredGig2/1/2 phy-number 1
client 1 bandwidth 70
client 2 bandwidth 10
client 3 bandwidth 20
#
二、配置华为设备
1、接口使能Flex-E功能
#
flexe enable port 4/0/0
#
2、配置phy-number参数,phy-num为1
#
interface FlexE-50|100G4/0/0
port-speed 100GE
description Link-to-H3C
undo shutdown
phy-number 1
#
3、子卡上创建接口组,group number为305021
#
flexe group 52
flexe-groupnum 305021
binding interface FlexE-50|100G4/0/0
#
4、配置FlexE切片,设置切片client ID和带宽,client ID分别为1、2、3,带宽分配为70、10、20.。
#
flexe client-instance 1052 flexe-group 52 flexe-type full-function port-id 4
flexe-clientid 1
flexe-bandwidth 70
#
flexe client-instance 2052 flexe-group 52 flexe-type full-function port-id 5
flexe-clientid 2
flexe-bandwidth 10
#
flexe client-instance 3052 flexe-group 52 flexe-type full-function port-id 6
flexe-clientid 3
flexe-bandwidth 20
#
三、结果确认
完成上述配置后,在H3C设备可以看到有3个Flex-E切片接口,如下:
#
interface FlexE2/1/305021:1
port link-mode route
#
interface FlexE2/1/305021:2
port link-mode route
#
interface FlexE2/1/305021:3
port link-mode route
#
在华为设备上也可以看到如下3个接口:
#
interface FlexE4/0/4
#
interface FlexE4/0/5
#
interface FlexE4/0/6
#
1、Flex-E功能对接,要求两端设备的Group Number、Phy-num、client ID必须配置一致
2、Flex-E切片接口的功能和物理口一样,可以配置IP、配置路由协议、QOS策略等。
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作