• 全部
  • 经验案例
  • 典型配置
  • 技术公告
  • FAQ
  • 漏洞说明
  • 全部
  • 全部
  • 大数据引擎
  • 知了引擎
产品线
搜索
取消
案例类型
发布者
是否解决
是否官方
时间
搜索引擎
匹配模式
高级搜索

某局点S10508X 出端口流量速率100%,配置本地镜像后速率回落正常问题

  • 0关注
  • 0收藏 732浏览
粉丝:29人 关注:3人

组网及说明

/

告警信息

/

问题描述

设备型号:S10508X Version 7.1.070, Release 7624P12

现场监控平台反馈当前设备的g1/3/0/3接口,出方向流量速率100%,存在异常;按理只有如下四个接口上来的流量,会通过G1/3/0/3发往华为云:XGE2/2/0/5    XGE1/2/0/6  聚合  Bridge-Aggregation40   XGE1/2/0/9   XGE2/2/0/9 ,不会达到这么高的流量.

 

于是前方配置本地镜像,想看看是否流量异常转发到路由口了导致,但是配置镜像后g1/3/0/3出方向速率立刻回落正常,取消镜像马上又达到100%.

 

[WZ-Croe-S10508X]dis interface  GigabitEthernet 1/3/0/3

GigabitEthernet1/3/0/3

Current state: UP

Line protocol state: UP

Description: To-HuaWei-Cloud

Bandwidth: 100000 kbps

Maximum transmission unit: 1500

Allow jumbo frames to pass

Broadcast max-ratio: 100%

Multicast max-ratio: 100%

Unicast max-ratio: 100%

Known-unicast max-ratio: 100%

Internet address: 10.1.120.1/30 (Primary)

IP packet frame type: Ethernet II, hardware address: ecda-59b3-e401

IPv6 packet frame type: Ethernet II, hardware address: ecda-59b3-e401

Loopback is not set

Media type is twisted pair, port hardware type is 1000_BASE_T_AN_SFP

Port priority: 0

100Mbps-speed mode, Full-duplex mode

Link speed type is autonegotiation, link duplex type is autonegotiation

Flow-control is not enabled

Maximum frame length: 9216

Last link flapping: 10 weeks 2 days 1 hours 43 minutes

Last clearing of counters: 16:23:39 Thu 05/11/2023

Current system time:2023-05-11 16:26:21

Last time when physical state changed to up:2023-02-28 14:42:52

Last time when physical state changed to down:2023-02-28 14:42:49

Peak input rate: 664667 bytes/sec, at 2023-05-11 16:24:56

 Peak output rate: 12176953 bytes/sec, at 2023-05-11 16:26:17

 Last 5 seconds input: 394 packets/sec 282498 bytes/sec 2%

Last 5 seconds output: 14217 packets/sec 12176953 bytes/sec 100%

Input (total):  57192 packets, 41721604 bytes

         57140 unicasts, 52 broadcasts, 0 multicasts, 0 pauses

Input (normal):  57192 packets, - bytes

         57140 unicasts, 52 broadcasts, 0 multicasts, 0 pauses

Input:  0 input errors, 0 runts, 0 giants, 0 throttles

         0 CRC, 0 frame, - overruns, 0 aborts

         - ignored, - parity errors

Output (total): 164950 packets, 113717472 bytes

         164928 unicasts, 0 broadcasts, 22 multicasts, 0 pauses

Output (normal): 164950 packets, - bytes

         164928 unicasts, 0 broadcasts, 22 multicasts, 0 pauses

Output: 0 output errors, - underruns, - buffer failures

         0 aborts, 0 deferred, 0 collisions, 0 late collisions

         0 lost carrier, - no carrier

IPv4 traffic statistics:

Last 5 seconds input rate: 0 packets/sec, 0 bytes/sec

Last 5 seconds output rate: 0 packets/sec, 0 bytes/sec

Input: 0 packets, 0 bytes

Output: 0 packets, 0 bytes

IPv6 traffic statistics:

Last 5 seconds input rate: 0 packets/sec, 0 bytes/sec

Last 5 seconds output rate: 0 packets/sec, 0 bytes/sec

Input: 0 packets, 0 bytes

Output: 0 packets, 0 bytes

[WZ-Croe-S10508X]dis int link-info main  | in 1/3/0/3

GE1/3/0/3        UP   UP             4%     100%              0              0

 

[WZ-Croe-S10508X]dis counters rate outbound interface GigabitEthernet 1/3/0/3

Usage: Bandwidth utilization in percentage

Interface            Usage (%)   Total (pps)   Broadcast (pps)   Multicast (pps)

GE1/3/0/3                   98         15726                --                --

多次收集下面命令,有明显丢包;

[WZ-Croe-S10508X]dis qos queue-statistics interface GigabitEthernet 1/3/0/3 outbo

und

Interface: GigabitEthernet1/3/0/3

Direction: outbound

Forwarded: 3226758 packets, 2755851482 bytes

Dropped: 45947130 packets, 41932815301 bytes

Queue 0

  Forwarded: 0 packets, 0 bytes, 0 pps, 0 bps

  Dropped: 0 packets, 0 bytes

  Current queue length: 0 packets

Queue 1

  Forwarded: 0 packets, 0 bytes, 0 pps, 0 bps

  Dropped: 0 packets, 0 bytes

  Current queue length: 0 packets

Queue 2

  Forwarded: 3226706 packets, 2755844142 bytes, 13631 pps, 99703560 bps

  Dropped: 45947130 packets, 41932815301 bytes

  Current queue length: 2778 packets

 

 

如果配置镜像,流量就能下来:

[WZ-Croe-S10508X]dis counters  rate inbound interface GigabitEthernet 1/3/0/3

Usage: Bandwidth utilization in percentage

Interface            Usage (%)   Total (pps)   Broadcast (pps)   Multicast (pps)

GE1/3/0/3                    2           307                --                --

 

Overflow: More than 14 digits.

       --: Not supported.

[WZ-Croe-S10508X]

[WZ-Croe-S10508X]

[WZ-Croe-S10508X]

[WZ-Croe-S10508X]

[WZ-Croe-S10508X]

[WZ-Croe-S10508X]int g1/3/0/3

[WZ-Croe-S10508X-GigabitEthernet1/3/0/3]dis this

#

interface GigabitEthernet1/3/0/3

port link-mode route

description To-HuaWei-Cloud

flow-interval 5

ip address 10.1.120.1 255.255.255.252

mirroring-group 4 mirroring-port both

#

过程分析

核查发现是另外一个镜像组3配置不规范,Prob vlan配置了对应虚接口:

mirroring-group 3 remote-probe vlan 4000

#

interface Vlan-interface4000

description TO-LianRuan-Mirroring

#

删除interface Vlan-interface4000解决.

解决方法

配置错误,导致报文异常上送cpu复制转发,带宽高,删除interface Vlan-interface4000解决.

该案例对您是否有帮助:

您的评价:1

若您有关于案例的建议,请反馈:

0 个评论

该案例暂时没有网友评论

编辑评论

举报

×

侵犯我的权益 >
对根叔知了社区有害的内容 >
辱骂、歧视、挑衅等(不友善)

侵犯我的权益

×

泄露了我的隐私 >
侵犯了我企业的权益 >
抄袭了我的内容 >
诽谤我 >
辱骂、歧视、挑衅等(不友善)
骚扰我

泄露了我的隐私

×

您好,当您发现根叔知了上有泄漏您隐私的内容时,您可以向根叔知了进行举报。 请您把以下内容通过邮件发送到pub.zhiliao@h3c.com 邮箱,我们会尽快处理。
  • 1. 您认为哪些内容泄露了您的隐私?(请在邮件中列出您举报的内容、链接地址,并给出简短的说明)
  • 2. 您是谁?(身份证明材料,可以是身份证或护照等证件)

侵犯了我企业的权益

×

您好,当您发现根叔知了上有关于您企业的造谣与诽谤、商业侵权等内容时,您可以向根叔知了进行举报。 请您把以下内容通过邮件发送到 pub.zhiliao@h3c.com 邮箱,我们会在审核后尽快给您答复。
  • 1. 您举报的内容是什么?(请在邮件中列出您举报的内容和链接地址)
  • 2. 您是谁?(身份证明材料,可以是身份证或护照等证件)
  • 3. 是哪家企业?(营业执照,单位登记证明等证件)
  • 4. 您与该企业的关系是?(您是企业法人或被授权人,需提供企业委托授权书)
我们认为知名企业应该坦然接受公众讨论,对于答案中不准确的部分,我们欢迎您以正式或非正式身份在根叔知了上进行澄清。

抄袭了我的内容

×

原文链接或出处

诽谤我

×

您好,当您发现根叔知了上有诽谤您的内容时,您可以向根叔知了进行举报。 请您把以下内容通过邮件发送到pub.zhiliao@h3c.com 邮箱,我们会尽快处理。
  • 1. 您举报的内容以及侵犯了您什么权益?(请在邮件中列出您举报的内容、链接地址,并给出简短的说明)
  • 2. 您是谁?(身份证明材料,可以是身份证或护照等证件)
我们认为知名企业应该坦然接受公众讨论,对于答案中不准确的部分,我们欢迎您以正式或非正式身份在根叔知了上进行澄清。

对根叔知了社区有害的内容

×

垃圾广告信息
色情、暴力、血腥等违反法律法规的内容
政治敏感
不规范转载 >
辱骂、歧视、挑衅等(不友善)
骚扰我
诱导投票

不规范转载

×

举报说明

提出建议

    +

亲~登录后才可以操作哦!

确定

亲~检测到您登陆的账号未在http://hclhub.h3c.com进行注册

注册后可访问此模块

跳转hclhub

你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作