不涉及
设备插了多块业务板卡,dipslay interface时只有0槽位接口能看到bandwidth信息,其他槽位接口看不到,显示如下:
interface HundredGigE0/0/1
port link-mode route
#
interface HundredGigE1/0/1
port link-mode route
HundredGigE0/0/1
Current state: DOWN
Line protocol state: DOWN
Description: HundredGigE0/0/1 Interface
Bandwidth: 100000000 kbps
Flow-control is not enabled
HundredGigE1/0/1
Current state: DOWN
Line protocol state: DOWN
Description: HundredGigE1/0/1 Interface
Flow-control is not enabled
在查看命令手册时提到:
Bandwidth 接口的期望带宽值,当该参数的取值为0时,不显示该参数
加上这些接口没有手工配置过,也都是down状态,说明这些接口的bandwidth取值为0。
后续确认如果接口从来没有UP过,那么bandwidth就是0,只要UP过会保留最后一次UP的速率。
可以通过自环接口UP来获取速率。
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作