NE80/NE40系列路由器IPv6路由协议OSPFv3的配置

NE80/NE40系列路由器IPv6路由协议

OSPFv3的配置

一、组网需求：

    RTA、RTB与RTC均为NE40，版本Version 5.30，RELEASE 0228；通过配置IPv6动态路由协议使相互间可以学习到对方的Loopback地址，从而达到全网连通。

二、组网图：

   

三、配置步骤：

1.RTA的配置：

ipv6

ospfv3 1

 router-id 1.1.1.1

 import-route direct

 area 0.0.0.0

interface Ethernet1/0/3

undo shutdown

 ipv6 address 1:102::1/64

 ospfv3 1 area 0.0.0.0                                                                          

interface LoopBack0                                                            

 ipv6 address 1::1/128                                                         

 ospfv3 1 area 0.0.0.0                                                         

2.RTB的配置：

ospfv3 1

 router-id 2.2.2.2

 import-route direct

 area 0.0.0.0

 area 0.0.0.1

interface Ethernet5/0/4

undo shutdown

 ipv6 address 1:102::2/64

 ospfv3 1 area 0.0.0.0

interface Ethernet5/0/1

undo shutdown

 ipv6 address 1:203::2/64

 ospfv3 1 area 0.0.0.1

interface LoopBack0                                                            

 ipv6 address 1::2/128                                                         

 ospfv3 1 area 0.0.0.0

3.RTC的配置

ospfv3 1

 router-id 3.3.3.3

 import-route direct

 area 0.0.0.1

interface Ethernet5/0/1

undo shutdown

 ipv6 address 1:203::3/64

 ospfv3 1 area 0.0.0.1

interface LoopBack0                                                            

 ipv6 address 1::3/128                                                          

 ospfv3 1 area 0.0.0.1

四、配置关键点：

1.在ospfv3 模式下area 0.0.0.0，这条命令执行完成后没有显示，只有在接口使能后才会出现；

2.Router-id 必须配置，否则邻居无法正常建立。