The configuration of S5600 UDP-Helper
I Requirement for the diagram
PC1 connect to PC2 by switch,IP address of PC1 is192.168.1.1/24,IP address of PC2 is 10.2.72.1/24,PC1 could get to PC2 by routing.It needs to use UDP-Helper to make PC1 get to PC2 by computer searching.(The packet of computer searching is UDP with port 137).
II Network topology
III Steps of configuration
1. Enabel UDP-Helper on Switch 1
<H3C> system-view
[H3C] udp-helper enable
2. Define the UDP packet with port 137 should be transferred, here show the configuration has been set
[H3C] udp-helper port 137
Port has been configured. Please check the port again.
3. Define the destination server to which UDP packet transfer
[H3C] interface Vlan-interface 20
[H3C-Vlan-interface20] udp-helper server 10.2.72.1
IV Key notes in the configuration
None
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作