The configuration of IRF on S5600 switches
I Requirement for the diagram
Configure Unit ID、Unit name、Fabric name of 4 devices,make the 4 devices to a fabric
Specific Requirement:
1. Each Unit ID of the 4 devices is 1、2、3、4;
2. Each Unit name of the 4 devices is Unit1、Unit2、Unit3、Unit4 .Fabric name is hello.
II Network topology
III Steps of configuration
Configuration of Switch A:
1. Set Unit ID is 1
<Switch> system-view
[Switch] change unit-id 1 to 1
2.Set Unit name is Unit1
[Switch] set unit 1 name Unit1
3.Set fabric name is hello
[Switch] sysname hello
Configuration of Switch B:
1.Set Unit ID is 2
<Switch> system-view
[Switch] change unit-id 1 to 2
2.Set Unit name is Unit2
[Switch] set unit 2 name Unit2
3.Set fabric name is hello
[Switch] sysname hello
The configuration of Switch C and Switch D is similar with Switch A and Switch B,please set Unid ID , Unit name of Switch C and Switch D is Unit ID 3,4 , Unit Name is Unit3,Unit4.
IV Key notes in the configuration
1. Please make sure the software version of every unit is the same, and with right
connection;
2. The configuration above should be set before fabric building. If there is the Unit ID,FTM module be able to give unit a number automatically;
3. When fabric works normally, fabric could be regarded as a one device.
4. The case could also be applyed on H3C S3600 device.
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作