Typical Configuration Of HDLC on AR28、AR46 Series Routers
[Requirements]
RouterA and RouterB interwork through HDLC.
[Networking diagram]
[Configuration script]
Configuration script (RouterA)
#
sysname RouterA
#
radius scheme system
#
domain system
#
interface Serial0/0
link-protocol hdlc
ip address 20.1.1.1 255.255.255.0
#
interface NULL0
#
user-interface con 0
user-interface vty 0 4
#
return
Configuration script (RouterB)
#
sysname RouterB
#
radius scheme system
#
domain system
#
interface Serial0/0
link-protocol hdlc
ip address 20.1.1.2 255.255.255.0
#
interface NULL0
#
user-interface con 0
user-interface vty 0 4
#
return
[Verification]
The two routers can successfully ping each other.
[Tip]
1. Make sure that the keepalive values on the two routers are the same, and it defaults to 10s. You can cancel keepalive (undo timer hold) at both sides if necessary.
2. The Cisco equipment defaults to encapsulate with HDLC, while the Huawei-3Com equipment defaults to encapsulate with PPP, which shall be taken into consideration during interworking. It is strongly suggested that you use the PPP with standard RFC documents for encapsulation.
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作