Typical Configuration Of Sharing DCC (Flexible DDR)

Typical Configuration Of Sharing DCC (Flexible DDR)

[Configuration script]

Caller side configuration script

# dialer-rule 1 ip permit                //Configure dialing ACL # interface Aux0 baudrate 57600 async mode protocol link-protocol ppp undo dialer enable-circular      //Disable polling DCC (that is, enable sharing DCC) dialer-group 1              //Apply the dialing ACL dialer bundle-member 1                        /Associate it with three bundles, but it is bound to only one of them during dialing dialer bundle-member 2                                 dialer bundle-member 3 # interface Dialer0 link-protocol ppp ppp pap local-user usera password simple passwd ip address ppp-negotiate dialer user usera dialer bundle 1                  //Specify dialer 0 as bundle 1 dialer number 1234               //Configure dialing number # interface Dialer1 link-protocol ppp ppp chap user usera ppp chap password simple passwd ip address ppp-negotiate dialer-group 1 dialer user usera dialer bundle 2                 //Specify dialer 1 as bundle 2 dialer number 4567 # interface Dialer2 link-protocol ppp ppp pap local-user usera password simple passwd ip address 10.1.1.2 255.2 55.255.0 dialer-group 1 dialer user usera dialer bundle 3                 //Specify dialer 2 as bundle 3 dialer number 8888 # ip route-static 0.0.0.0 0.0.0.0 Dialer 0 preference 60    /Calls from different routes pass different dialer interfaces/ ip route-static 10.0.0.0 0.0.0.0 Dialer 1 preference 60 ip route-static 20.0.0.0 0.0.0.0 Dialer 2 preference 60 # user-interface aux 0 modem both                     //Enable modem on the AUX interface speed 57600 #