• 全部
  • 经验案例
  • 典型配置
  • 技术公告
  • FAQ
  • 漏洞说明
  • 全部
  • 全部
  • 大数据引擎
  • 知了引擎
产品线
搜索
取消
案例类型
发布者
是否解决
是否官方
时间
搜索引擎
匹配模式
高级搜索

ADSL-I Modules of H3C Series Routers

2007-09-27 发表
  • 0关注
  • 0收藏 552浏览
粉丝: 关注:

ADSL-I Modules of H3C Series Routers

I.         Preface

With the rapid development and deep into the people’s heart of IT and network technologies, the requirement on network bandwidth is increasingly higher. Network construction and transformation wave are also stepping into peak period. At the same time, reducing network operation cost and introducing competition system will lead to a significant reduction of network construction investment. The building of new network and the alteration of existing network also have the same important characteristics, i.e. high performance and high bandwidth.

 

Previously, medium/low-end router can provide interfaces such as ISDN to meet the small and medium businesses requirements on Internet. Today, with the maturity and development of DSL technology, ADSL gradually becomes the main approach of SMB to access the Internet for its high bandwidth.

ADSL, also called as asymmetrical digital subscriber loop, is an asymmetrical version of xDSL. In general, ADSL can provide users with 32Kbps8Mbps of downlink rate and 32K1Mbps of uplink rate while not interfering the general communication services like voice or ISDN on the same line.

 

Enabling ADSL interface on medium/low end router can provide a new solution for various SMBs or some large branches and offices with requirements on high bandwidth. With digital code modulation technology, ADSL uses common line as transport media to directly connect to the operator’s DSLAMDigital Subscriber's Loop Access Multiplexerand then to ATM/IP backbone via DSLAM, meeting requirements such as high speed data communication and video on demand.

II.      1ADSL-I/2ADSL-I Module

1         Introduction

1ADSL-I/2ADSL-I is the short of 1/2 port ADSL over ISDN interface module, where ADSL and ISDN are the abbreviation of Asymmetric Digital Subscriber's Loop and Integrated Services Digital Network respectively. RJ11 interface provided by ADSL-I module is equal to WAN interface. LAN users are allowed to directly connect to operator’s DSLAM (Digital Subscriber's Loop Access Multiplexer) through common analog user line, and then connect to ATM/IP backbone or Internet through DSLAM, meeting requirements such as high speed data communication and video on demand. ADSL-I occupies bands higher than 138 KHz to provide data transmission service, guaranteeing no adverse effects on ISDN service. Usually 32Kbps8Mbps of downlink rate and 32Kbps1Mbps of uplink rate are provided to users.

The detailed features of ADSL-I module in system are as follows:

1.        Support manually activate/deactivate ADSL line and provide convenient troubleshooting methods;

2.        Support G.992.1 interface standard and can be configured as adaptive;

3.        Support grid coding function of ADSL interface, enhancing the stability of ADSL connection.

 

2         Module Appearance

The appearance of 1ADSL-I/2ADSL-I module is shown as follows respectively:

1ADSL-I module appearance diagram

 

 

 

2ADSL-I module appearance diagram

Module Interface Indicator

1ADSL-I/2 ADSL-I module panel is shown as follows:

1 ADSL-I module panel

2ADSL-I module panel

The following table shows implication of various indicators:

Implication of 1ADSL-I/2ADSL-I module indicator

LINK

Extinguished represents the link is not connected; lighting represents the link is connected.

ACT

Extinguished represents no data has been received/sent; flashing represents some data has been received/sent.

 

3         Module Interface Cable

1ADSL-I/2ADSL-I module interface cable is common line.

&  Note:

The standard configuration of 1ADSL/2ADSL module includes common line. User can independently purchase external spliter depending on requirements.

 

Connection of Module Interface Cable

To cabling ADSL-I module interface, installing a splitter is needed. Please cabling according to the following steps:

Step 1: one side of line is attached to RJ11 socket of ADSL-1 module of a router, the other is attached to the internal ADSL-I interface of a splitter;

Step 2: use the second line to attach ISDN NT1 to the splitter;

Step 3: use the third line to attach the foreign ADSL-I interface of the splitter to ISDN network.

ADSL-I module connection diagram

4         Module Interface Attributes

1ADSL-I/2ADSL-I module interface attributes

Attributes

1ADSL-I module

2ADSL-I module

Type of connector

RJ11

Interface number

1

2

Interface standard

G. 992.1

Interface rate

Downlink rate is 8Mbps, uplink rate is 1024Kbps

Type of interface cable

ADSL-I module interface cable is common line

Service

Access to ADSL over ISDN

 

5         Networking Application

Like ADSL module.

 

 

若您有关于案例的建议,请反馈:

作者在2007-09-27对此案例进行了修订
0 个评论

该案例暂时没有网友评论

编辑评论

举报

×

侵犯我的权益 >
对根叔知了社区有害的内容 >
辱骂、歧视、挑衅等(不友善)

侵犯我的权益

×

泄露了我的隐私 >
侵犯了我企业的权益 >
抄袭了我的内容 >
诽谤我 >
辱骂、歧视、挑衅等(不友善)
骚扰我

泄露了我的隐私

×

您好,当您发现根叔知了上有泄漏您隐私的内容时,您可以向根叔知了进行举报。 请您把以下内容通过邮件发送到pub.zhiliao@h3c.com 邮箱,我们会尽快处理。
  • 1. 您认为哪些内容泄露了您的隐私?(请在邮件中列出您举报的内容、链接地址,并给出简短的说明)
  • 2. 您是谁?(身份证明材料,可以是身份证或护照等证件)

侵犯了我企业的权益

×

您好,当您发现根叔知了上有关于您企业的造谣与诽谤、商业侵权等内容时,您可以向根叔知了进行举报。 请您把以下内容通过邮件发送到 pub.zhiliao@h3c.com 邮箱,我们会在审核后尽快给您答复。
  • 1. 您举报的内容是什么?(请在邮件中列出您举报的内容和链接地址)
  • 2. 您是谁?(身份证明材料,可以是身份证或护照等证件)
  • 3. 是哪家企业?(营业执照,单位登记证明等证件)
  • 4. 您与该企业的关系是?(您是企业法人或被授权人,需提供企业委托授权书)
我们认为知名企业应该坦然接受公众讨论,对于答案中不准确的部分,我们欢迎您以正式或非正式身份在根叔知了上进行澄清。

抄袭了我的内容

×

原文链接或出处

诽谤我

×

您好,当您发现根叔知了上有诽谤您的内容时,您可以向根叔知了进行举报。 请您把以下内容通过邮件发送到pub.zhiliao@h3c.com 邮箱,我们会尽快处理。
  • 1. 您举报的内容以及侵犯了您什么权益?(请在邮件中列出您举报的内容、链接地址,并给出简短的说明)
  • 2. 您是谁?(身份证明材料,可以是身份证或护照等证件)
我们认为知名企业应该坦然接受公众讨论,对于答案中不准确的部分,我们欢迎您以正式或非正式身份在根叔知了上进行澄清。

对根叔知了社区有害的内容

×

垃圾广告信息
色情、暴力、血腥等违反法律法规的内容
政治敏感
不规范转载 >
辱骂、歧视、挑衅等(不友善)
骚扰我
诱导投票

不规范转载

×

举报说明

提出建议

    +

亲~登录后才可以操作哦!

确定

亲~检测到您登陆的账号未在http://hclhub.h3c.com进行注册

注册后可访问此模块

跳转hclhub

你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作