Aolynk DR814 add reserved mapping for ip camera

Aolynk DR814 add reserved mapping for ip camera

1.    Customer requirements

DR814 as the NAT gateway between the customer’s intranet and the internet, the customer wants to control the camera connected the DR814 through the internet.

2. Topology

3．Step by step configuration guide

 

Step1  Find the security interface configuration page as below and Make sure NAT is enalbed.

Step2 Then click Advanced NAT configuration…to enter the page as below

Step3 Click Add Reserved Mapping…to enter the page as below and fill in with camera address, Transport type and the port 80

Step4 Click <Add Reserved Mapping>…to enter the page as below .

Step5 Add another mapping filled with camera address, Transport type and the port 4321

Step6 Click <Add Reserved Mapping> after the configuration is complete.

Step7 Do remember to return to main interface to save the configuration.

      

4．Note

  IN step 1, the default LAN port of DR814 had modified to 192.168.0.1, you should use 192.168.0.1 to enter the configuration page. And the camera address is 192.168.0.10, in other words, the default LAN port and the camera address you had set should in same net segment.