S3110交换机在两个端口做链路聚合

# 创建二层聚合接口1。

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] quit

# 分别将端口Ethernet1/0/1至Ethernet1/0/3加入到聚合组1中。

[DeviceA] interface ethernet1/0/1

[DeviceA-Ethernet1/0/1] port link-aggregation group 1

[DeviceA-Ethernet1/0/1] quit

[DeviceA] interface ethernet1/0/2

[DeviceA-Ethernet1/0/2] port link-aggregation group 1

[DeviceA-Ethernet1/0/2] quit

[DeviceA] interface ethernet1/0/3

[DeviceA-Ethernet1/0/3] port link-aggregation group 1

[DeviceA-Ethernet1/0/3] quit

# 配置二层聚合接口1为Trunk端口，并允许VLAN 10和20的报文通过。

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] port link-type trunk

[DeviceA-Bridge-Aggregation1] port trunk permit vlan 10 20

 Please wait... Done.

 Configuring Ethernet1/0/1... Done.

 Configuring Ethernet1/0/2... Done.

 Configuring Ethernet1/0/3... Done.

[DeviceA-Bridge-Aggregation1] quit

# 查看Device A上所有聚合组的摘要信息。

[DeviceA] display link-aggregation summary

Aggregation Interface Type:

BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation

Aggregation Mode: S -- Static, D -- Dynamic

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Actor System ID: 0x8000, 000f-e2ff-0001

AGG         AGG       Partner ID               Select Unselect   Share

Interface   Mode                               Ports  Ports      Type

-------------------------------------------------------------------------------

BAGG1       S         none                     3      0          Shar

以上信息表明，聚合组1为负载分担类型的二层静态聚合组，包含有三个选中端口。