新接口加入聚合组，怎么同步聚合组配置

手动把命令敲上去

您好，请知：

先把新的接口加入聚合组，然后在聚合组内添加配置即可。

以下是配置要点请参考：

<H3C>sys

[H3C]sysname SW1

[SW1]vlan 10

[SW1-vlan10]quit

[SW1]int gi 1/0/3

[SW1-GigabitEthernet1/0/3]port link-type access

[SW1-GigabitEthernet1/0/3]port access vlan 10

[SW1-GigabitEthernet1/0/3]description <connect to PC>

[SW1-GigabitEthernet1/0/3]quit

[SW1]int Bridge-Aggregation 1   //创建链路聚合组1

[SW1-Bridge-Aggregation1]quit

[SW1]int range gi 1/0/1 to gi 1/0/2

[SW1-if-range]port link-aggregation group 1  //将链路聚合组应用到接口

[SW1-if-range]quit

[SW1]int Bridge-Aggregation 1  //继续配置链路聚合组1

[SW1-Bridge-Aggregation1]port link-type trunk

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]undo port trunk permit vlan 1

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]port trunk permit vlan 10

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]quit

https://zhiliao.h3c.com/Theme/details/97573

你就在聚合组里把配置，重新复制粘贴一次即可，