S5120-28P-Li版本5.2
默认的VLAN1,IP设置 为192.168.100.2
需要划分三个VLAN分别为VLAN 10,20,30
对应的IP为:192.168.10.1 20.1 30.1
是否支持,如果支持请问添加IP的命令是什么
请教高手!
谢谢
H3C Comware Platform Software Comware Software, Version 5.20, Release 1513P62 Copyright (c) 2004-2013 Hangzhou H3C Tech. Co., Ltd. All rights reserved. H3C S5120-28P-LI uptime is 0 week, 0 day, 0 hour, 0 minute H3C S5120-28P-LI 128M bytes DRAM 128M bytes Nand Flash Memory Config Register points to Nand Flash Hardware Version is REV.A CPLD Version is 002 Bootrom Version is 163 [SubSlot 0] 24GE+4SFP Hardware Version is REV.A
[H3C-vlan10]ip add 192.168.10.1 24 ^ % Unrecognized command found at '^' position. [H3C-vlan10]
(0)
报错!!!
[H3C]dis vlan
Total 2 VLAN exist(s).
The following VLANs exist:
1(default), 10,
[H3C]int vlan 10
The number of VLAN interfaces exceeded the maximum.
[H3C]
(0)
暂无评论
您好,请知:
需创建VLAN后再配置VLAN IP,参考命令如下:
vlan 10
quit
int vlan 10
ip address 192.168.10.1 24
quit
如果出现The number of VLAN interfaces exceeded the maximum.,说明int vlan的虚接口的数量已经到了上限。
(0)
暂无评论
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作
举报
×
侵犯我的权益
×
侵犯了我企业的权益
×
抄袭了我的内容
×
原文链接或出处
诽谤我
×
对根叔社区有害的内容
×
不规范转载
×
举报说明
暂无评论