4台H3c交换做完堆叠上核心，做聚合，怎么配置

正常堆叠就行了

比如之前是int rang g1/0/1 to g1/0/2

堆叠之后无非 就是 int  rang g1/1/0/1 to g1/1/0/2

您好，请知：

正常创建聚合组并加入到物理端口就可以了，以下是参考命令：

[SW1]int Bridge-Aggregation 1   //创建链路聚合组1

[SW1-Bridge-Aggregation1]quit

[SW1]int range gi 1/0/1 to gi 1/0/2

[SW1-if-range]port link-aggregation group 1  //将链路聚合组应用到接口

[SW1-if-range]quit

[SW1]int Bridge-Aggregation 1  //继续配置链路聚合组1

[SW1-Bridge-Aggregation1]port link-type trunk

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]undo port trunk permit vlan 1

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]port trunk permit vlan 10

Configuring GigabitEthernet1/0/1 done.

Configuring GigabitEthernet1/0/2 done.

[SW1-Bridge-Aggregation1]quit