IFNET/3/PHY_UPDOWN: Physical state on the interface Ten-GigabitEthernet1/0/1 changed to down. IFNET/5/LINK_UPDOWN: Line protocol state on the interface Ten-GigabitEthernet1/0/1 changed to down. LAGG/6/LAGG_INACTIVE_PHYSTATE: Member port XGE1/0/1 of aggregation group BAGG1 changed to the inactive state, because the physical or line protocol state of the port was down. DRNI/6/DRNI_IFEVENT_DR_NOSELECTED: Local DR group 1 does not have selected member ports. IFNET/3/PHY_UPDOWN: Physical state on the interface Ten-GigabitEthernet1/0/1 changed to up. LAGG/6/LAGG_ACTIVE: Member port XGE1/0/1 of aggregation group BAGG1 changed to the active state. IFNET/5/LINK_UPDOWN: Line protocol state on the interface Ten-GigabitEthernet1/0/1 changed to up. DRNI/6/DRNI_IFEVENT_DR_SELECTED: Local DR group 1 has selected member ports. LLDP/6/LLDP_CREATE_NEIGHBOR: Nearest bridge agent neighbor created on port Ten-GigabitEthernet1/0/1 (IfIndex 1), neighbor's chassis ID is 7450-4ebe-0422, port ID is Ten-GigabitEthernet1/2/0.
(0)
最佳答案
以下是光模块相关信息的查询命令,请悉知:
[H3C]display transceiver manuinfo interface //查看光模块生产厂家信息
[H3C]dis transceiver interface GigabitEthernet 1/0/1 //查看光模块的信息
[H3C]dis transceiver diagnosis interface GigabitEthernet 1/0/1 //查看光口的收发情况
[H3C]dis transceiver alarm interface GigabitEthernet 1/0/1 //查看光口的告警信息
光口不通,以下是排查要点,请参考:
1、检查光模块是否能被设备读取并识别。
2、检查光路的衰减是否在正常的阈值范围内。
3、检查光纤的收、发是否接反了。
4、检查本端和对端的光模块类型、速率、波长、距离是否一致。
5、检查本端和对端的物理端口的速率、双工模式是否一致。
(0)
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作
举报
×
侵犯我的权益
×
侵犯了我企业的权益
×
抄袭了我的内容
×
原文链接或出处
诽谤我
×
对根叔社区有害的内容
×
不规范转载
×
举报说明
暂无评论