vrrp不能添加RBM属性

按顺序配置，建议删了重新来一遍

# 使用两台Device进行HA组网，Device A作为主设备，Device B作为备设备。当Device A或其链路发生故障时，由Device B接替Device A继续工作，保证业务不中断。

[DeviceA] remote-backup group

[DeviceA-remote-backup-group] remote-ip 10.2.1.2

[DeviceA-remote-backup-group] local-ip 10.2.1.1

[DeviceA-remote-backup-group] >gigabitethernet 1/0/3

[DeviceA-remote-backup-group] device-role primary

RBM_P[DeviceA-remote-backup-group] undo backup-mode

RBM_P[DeviceA-remote-backup-group] hot-backup enable

RBM_P[DeviceA-remote-backup-group] configuration auto-sync enable

RBM_P[DeviceA-remote-backup-group] configuration sync-check interval 12

RBM_P[DeviceA-remote-backup-group] quit

# 配置VRRP备份组，并与HA关联。实现HA对VRRP备份组的统一管理和流量引导。

RBM_P[DeviceA] interface gigabitethernet 1/0/1

RBM_P[DeviceA-GigabitEthernet1/0/1] vrrp vrid 1 virtual-ip 2.1.1.3 active

RBM_P[DeviceA-GigabitEthernet1/0/1] quit

RBM_P[DeviceA] interface gigabitethernet 1/0/2

RBM_P[DeviceA-GigabitEthernet1/0/2] vrrp vrid 2 virtual-ip 10.1.1.3 active

RBM_P[DeviceA-GigabitEthernet1/0/2] quit