请问
上行口g1,下行口g4
interface GigabitEthernet1/0/1
port link-mode bridge
port link-type trunk
port trunk permit vlan 1 10 20
combo enable fiber
interface Vlan-interface10
ip address 192.168.0.253 255.255.255.0
vrrp vrid 1 virtual-ip 192.168.0.254
vrrp vrid 1 priority 120
vrrp vrid 1 track 1 priority reduced 30
#
interface Vlan-interface20
ip address 10.1.0.253 255.255.0.0
vrrp vrid 2 virtual-ip 10.1.0.254
[SW1-GigabitEthernet1/0/4]shutdown
[SW1]dis vrrp
IPv4 virtual router information:
Running mode : Standard
Total number of virtual routers : 2
Interface VRID State Running Adver Auth Virtual
pri timer(cs) type IP
---------------------------------------------------------------------
Vlan10 1 Backup 90 100 None 192.168.0.254
Vlan20 2 Backup 100 100 None 10.1.0.254
这种vrrp状态正常,但是如果g1口配置trunk permit vlan all
[SW1-GigabitEthernet1/0/1]dis th
#
interface GigabitEthernet1/0/1
port link-mode bridge
port link-type trunk
port trunk permit vlan all
combo enable fiber
[SW1]dis vrrp
IPv4 virtual router information:
Running mode : Standard
Total number of virtual routers : 2
Interface VRID State Running Adver Auth Virtual
pri timer(cs) type IP
---------------------------------------------------------------------
Vlan10 1 Master 120 100 None 192.168.0.254
Vlan20 2 Backup 100 100 None 10.1.0.254
为什么上行口g1配置permit vlan all下行口down就不切换vrrp主备?
暂无评论