vrrp切换

Sw1

interface GigabitEthernet1/0/1

 port link-type trunk

 port trunk permit vlan 1 10 20

interface Vlan-interface10

 ip address 192.168.0.253 255.255.255.0

 vrrp vrid 1 virtual-ip 192.168.0.254

 vrrp vrid 1 priority 120

 vrrp vrid 1 track 1 priority reduced 30

interface Vlan-interface20

 ip address 10.1.0.253 255.255.0.0

 vrrp vrid 2 virtual-ip 10.1.0.254

[SW1-GigabitEthernet1/0/4]shutdown

[SW1]dis vrrp

IPv4 virtual router information:

 Running mode : Standard

 Total number of virtual routers : 2

 Interface          VRID  State       Running Adver     Auth     Virtual

                                      pri     timer(cs) type     IP

 ---------------------------------------------------------------------

 Vlan10             1     Backup      90      100       None     192.168.0.254

 Vlan20             2     Backup      100     100       None     10.1.0.254

这种vrrp状态正常，但是如果g1口配置trunk permit vlan all

[SW1-GigabitEthernet1/0/1]dis th

#

interface GigabitEthernet1/0/1

 port link-mode bridge

 port link-type trunk

 port trunk permit vlan all

 combo enable fiber

这时上行口g4，down，主备不切换

[SW1]dis vrrp

IPv4 virtual router information:

 Running mode : Standard

 Total number of virtual routers : 2

 Interface          VRID  State       Running Adver     Auth     Virtual

                                      pri     timer(cs) type     IP

 ---------------------------------------------------------------------

 Vlan10             1     Master      120     100       None     192.168.0.254

 Vlan20             2     Backup      100     100       None     10.1.0.254

请问么上行口g1配置permit vlan all下行口down就不切换vrrp主备？