S5560交换机插上H3C原厂的光模块识别不了

1、交换机B上插的光模块是SFP-GE-LX-SM1310-A,SN:210231A563N169005718，交换机A上插的光模块是SFP-GE-LX-SM1310-A,SN:210231A563N169005717

2、交换机A的版本：

Type : S5560-30S-EI Software Ver : S5560-1121 PCB 1 Ver : VER.B FPGA Ver : 001 BootRom Ver : 123 CPLD 1 Ver : 003 Chip : 0 Learning Mode: IVL

交换机B的版本：

Status : Master Type : S5560-54C-EI Software Ver : S5560-1121 PCB 1 Ver : VER.A FPGA Ver : 001 BootRom Ver : 123 CPLD 1 Ver : 003 Chip : 0 Learning Mode: IVL

没有最新版本，你们可以发最新版本给我，我的邮箱：zhourungui@***.***

3、已经强制为双工和速率为1000了，还是不行。因为过保了，打过你们客服电话，不给服务了。

交换机A:

[H3C]dis int Ten-GigabitEthernet 1/0/28 Ten-GigabitEthernet1/0/28 Current state: DOWN Line protocol state: DOWN IP packet frame type: Ethernet II, hardware address: 1cab-3412-6824 Description: Ten-GigabitEthernet1/0/28 Interface Bandwidth: 1000000 kbps Loopback is not set Media type is optical fiber, Port hardware type is 1000_BASE_LX_SFP 1000Mbps-speed mode, full-duplex mode Link speed type is force link, link duplex type is force link

交换机B：

[SW4-H3C-S5560]dis int Ten-GigabitEthernet 1/0/52 Ten-GigabitEthernet1/0/52 Current state: DOWN Line protocol state: DOWN IP packet frame type: Ethernet II, hardware address: d461-feaf-eff4 Description: Ten-GigabitEthernet1/0/52 Interface Bandwidth: 1000000 kbps Loopback is not set Media type is optical fiber, Port hardware type is 1000_BASE_LX_SFP 1000Mbps-speed mode, full-duplex mode Link speed type is force link, link duplex type is force link

网络不通，十万火急！请帮忙解决！！