华三查看到上一节点接口带宽流量使用率怎么查看

<H3C>dis int ten X/X/X
Current state: UP
Line protocol state: UP
IP packet frame type: Ethernet II, hardware address: xxxx.xxxx.xxxx
Description:  XG X/X/X Interface
Bandwidth: 10000000 kbps
Loopback is not set
Media type is optical fiber, port hardware type is 10G_BASE_SR_SFP
10Gbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
Maximum frame length: 9416
Allow jumbo frames to pass
Broadcast max-ratio: 100%
Multicast max-ratio: 100%
Unicast max-ratio: 100%
PVID: 1
MDI type: Automdix
Port link-type: Trunk
VLAN Passing: 10, 102, 1002, 1005, 1020, 1600
VLAN permitted: 10, 102, 1002, 1005, 1020, 1600
Trunk port encapsulation: IEEE 802.1q
Port priority: 0
Last link flapping: 70 weeks 1 days 0 hours 14 minutes
Last clearing of counters: Never
Current system time:2024-03-01 16:48:14 cst+08:00:00
Last time when physical state changed to up:2022-10-27 16:18:20 cst+08:00:00
Last time when physical state changed to down:2022-04-19 15:05:00 cst+08:00:00
Peak input rate: 660675340 bytes/sec, at 2023-09-01 10:47:11
Peak output rate: 672617811 bytes/sec, at 2023-09-22 13:55:48
Last 300 seconds input: 69250 packets/sec 44391056 bytes/sec 4%
Last 300 seconds output: 98778 packets/sec 84055137 bytes/sec 7%

使用这个命令就能看到接口使用率，不过显示的是最后三百秒的一个平均数值，以上4%和7%就是，具体计算就是 实际流量大小/ Bandwidth就能得出这个使用率，但这儿要注意计算单位要一致。

直接查看接口

一般dis inter，高端设备dis int link-info

配置snmp结合外部监控软件实现，比如zabbix或者华三的IMC