acg1000-m 启动不了，罐装系统后，故障依旧

通过console口，进行了文件升级，升级后和之前一样，设备启动过程如下： U-Boot 2011.03 (Release Version: V3.2.1) (Build time: Jul 22 2014 - 10:22:58) Skipping PCIe port 0 BIST, reset not done. (port not configured) Skipping PCIe port 1 BIST, reset not done. (port not configured) BIST check passed. Warning: Clock descriptor tuple not found in eeprom, using defaults Warning: Board descriptor tuple not found in eeprom, using defaults CUST_MC6100 board revision major:1, minor:0, serial #: mc6100 OCTEON CN6120-AAP pass 1.1, Core clock: 800 MHz, IO clock: 600 MHz, DDR clock: 533 MHz (1066 Mhz DDR) Base DRAM address used by u-boot: 0x0f800000, size: 0x7fdb80 DRAM: 2 GiB Now running in RAM - U-Boot at: ffffffffc0000000 Clearing DRAM...... done Registered IDE device 0 from IDE bus:dev 0:0 Flash: 4 MiB PCIe: Port 0 is SGMII, skipping. PCIe: Port 1 link active, 1 lanes, speed gen1 PCI console init succeeded, 1 consoles, 1024 bytes each Net: octmgmt0, octmgmt1, octeth0, octeth1, octeth2, octeth3, octeth4, octeth5, octeth6, octeth7 Bus 0: OK Device 0: Model: SMI MODEL Firm: 20111006 Ser#: 20090410 00002F63 Type: Removable Hard Disk Capacity: 967.6 MB = 0.9 GB (1981728 x 512) SATA#0 (No RDY) SATA#1 (3.0 Gbps) USB: USB EHCI 1.00 scanning bus for devices... 1 USB Device(s) found Type the command 'usb start' to scan for USB storage devices. Press Ctrl+C to enter menuboot: 0 reading vmlinux.64 Reading data: |....................| 100% 88987344 bytes read argv[2]: quiet argv[3]: cOnsole=ttyS0,9600 argv[4]: numcores=2 Allocating memory for ELF segment: addr: 0xffffffff80100000 (adjusted to: 0x100000), size 0x5730500 ## Loading big-endian Linux kernel with entry point: 0xffffffff8074da80 ... Bootloader: Done loading app on coremask: 0x3 Starting cores 0x3 /sbin/rc starting Mounting file systems Setting up loopback fsck.fat 3.0.26 (2014-03-07) Starting check/repair pass. Starting verification pass. /dev/sdb1: 174 files, 11510/61879 clusters log disk part is sda1. [ 334.302125] INFO: task sync:1311 bl