IFNET/4/IF_RX_FLOW_FAILED_RESUME: The inbound traffic volume increases to the normal range on Ten-GigabitEthernet1/0/3.
IFNET/4/IF_RX_FLOW_FAILED_RESUME: -Slot=2; The inbound traffic volume increases to the normal range on Ten-GigabitEthernet2/0/3.
SHELL/6/SHELL_CMD_EXECUTESUCCESS: -Line=CHANNEL-User=-IPAddr=; Command display transceiver health interface in view shell succeed to be executed. Result=Success.
SHELL/6/SHELL_CMD_EXECUTESUCCESS: -Line=CHANNEL-User=-IPAddr=; Command display link-flap protection in view shell succeed to be executed. Result=Success.
IFNET/4/IF_ETHERNET_RX_FLOW_FAILED: -Slot=2; The inbound traffic volume drops below the threshold on Ten-GigabitEthernet2/0/3.
IFNET/4/IF_ETHERNET_RX_FLOW_FAILED: The inbound traffic volume drops below the threshold on Ten-GigabitEthernet1/0/3.
两台交换机堆叠,万兆分别直连服务器,流量大的时候会有丢包,官网没看到有对应详细日志说明,哪位知道上面日志所要表达的意思
disp inter ten1/0/3
Ten-GigabitEthernet1/0/3
Current state: UP
Line protocol state: UP
IP packet frame type: Ethernet II, hardware address: 642f-c746-9829
Description: Ten-GigabitEthernet1/0/3 Interface
Bandwidth: 10000000 kbps
Loopback is not set
Media type is optical fiber, Port hardware type is 10G_BASE_SR_SFP
10Gbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
Maximum frame length: 10000
Allow jumbo frames to pass
Broadcast max-ratio: 100%
Multicast max-ratio: 100%
Unicast max-ratio: 100%
Known-unicast max-ratio: 100%
PVID: 10
MDI type: Automdix
Port link-type: Access
Tagged VLANs: None
Untagged VLANs: 10
Port priority: 0
Last link flapping: 36 weeks 0 days 18 hours 43 minutes
Last clearing of counters: Never
Current system time:2024-07-25 14:52:14
Last time when physical state changed to up:2023-11-15 20:09:24
Last time when physical state changed to down:2023-11-15 20:06:22
Peak input rate: 19577489 bytes/sec, at 2024-04-12 11:51:12(并非出现流量高峰时间)
Peak output rate: 21290062 bytes/sec, at 2023-11-06 23:31:26(并非出现流量高峰时间)
Last 300 seconds input: 139 packets/sec 184004 bytes/sec 0%
Last 300 seconds output: 8 packets/sec 807 bytes/sec 0%
Input (total): 10123266457 packets, 11709053360494 bytes
10122494201 unicasts, 583 broadcasts, 769797 multicasts, 1876 pauses
Input (normal): 10123264581 packets, - bytes
10122494201 unicasts, 583 broadcasts, 769797 multicasts, 1876 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 1303997321 packets, 1136303822302 bytes
995162096 unicasts, 226594436 broadcasts, 82240789 multicasts, 0 pauses
Output (normal): 1303997321 packets, - bytes
995162096 unicasts, 226594436 broadcasts, 82240789 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
IPv4 traffic statistics:
Last 300 seconds input rate: 0 packets/sec, 0 bytes/sec
Last 300 seconds output rate: 0 packets/sec, 0 bytes/sec
Input: 0 packets, 0 bytes
Output: 0 packets, 0 bytes
IPv6 traffic statistics:
Last 300 seconds input rate: 0 packets/sec, 0 bytes/sec
Last 300 seconds output rate: 0 packets/sec, 0 bytes/sec
Input: 0 packets, 0 bytes
Output: 0 packets, 0 bytes
disp 其它端口也一样情况,看上面数据是超过了机器处理能力而出现pause帧,但不至于这么low吧,没有满端口全负荷运行的就这样了
(0)
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作
举报
×
侵犯我的权益
×
侵犯了我企业的权益
×
抄袭了我的内容
×
原文链接或出处
诽谤我
×
对根叔社区有害的内容
×
不规范转载
×
举报说明
暂无评论