我的环境是如组网图,ac和核心二层互联,二层捆绑配置trunk放行所需vlan,现在有个疑问,看配置手册举例的案例有些不明白,例如控制端口、数据端口是3层还是2层呢?3层的话接口需要配置ip么,2层接口要划分集群IP对应的vlan么 ?
[AC1-ccluster-member-1] cluster-link control bind interface GigabitEthernet 1/0/2
The system will shut down and then bring up the interface after activation the cloud cluster configuration. Continue? [Y/N]: y
[AC1-ccluster-member-1] cluster-link control bind interface GigabitEthernet 1/0/3
The system will shut down and then bring up the interface after activation the cloud cluster configuration. Continue? [Y/N]: y
# 在Ten-Gigabitethernet1/3/9上部署数据通道。为满足数据通道的带宽需求,推荐数据通道使用Ten-Gigabitethernet接口或至少2个Gigabitethernet接口。
[AC1-ccluster-member-1] cluster-link data bind interface Ten-GigabitEthernet 1/3/9
(0)
可以参考一下官网案例,设备间控制通道连接理解为irf堆叠的同步线路就可以了,接口下无需做任何配置保持默认的二层vlan1即可
https://www.h3c.com/cn/d_202501/2347935_30005_0.htm#_Toc180425828
(0)
请问MAD接口也是单独搞个二层捆绑接口,然后默认vlan么,我想着是对接核心的接口用二层捆绑,然后配置trunk,放通对应vlan(ap业务、管理等),是这样么
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作
举报
×
侵犯我的权益
×
侵犯了我企业的权益
×
抄袭了我的内容
×
原文链接或出处
诽谤我
×
对根叔社区有害的内容
×
不规范转载
×
举报说明
请问MAD接口也是单独搞个二层捆绑接口,然后默认vlan么,我想着是对接核心的接口用二层捆绑,然后配置trunk,放通对应vlan(ap业务、管理等),是这样么