S10506X-G设备,三层子接口下没有找到dot1q相关配置命令,是设备三层子接口不支持dot1q vlan终结吗?
[JLSH-HXJF-MES-S10506-02-Route-Aggregation100.4011]?
Route-aggregation interface view commands:
arp ARP module
attack-defense Configure the attack defense function
bandwidth Specify the expected bandwidth
bfd BFD module
blacklist Configure the blacklist function
dci Data center interconnect mode
ddns Dynamic Domain Name System (DDNS) module
default Restore the default settings
description Describe the interface
dhcp Dynamic Host Configuration Protocol (DHCP) commands
diagnostic-logfile Diagnostic log file configuration
display Display current system information
dual-stack Specify a dual-stack PBR policy
enable Enable functions
end Alias for 'return'
esi Specify an Ethernet segment identifier
evpn Ethernet virtual private network module
exit Alias for 'quit'
igmp Internet Group Management Protocol (IGMP) module
ip Specify IP configuration
ipsec IP Security module
ipv6 Specify IPv6 configuration
isis Configure interface parameters for IS-IS
local-proxy-arp Specify local proxy ARP function for same interface
local-proxy-nd Local ND proxy function
lock Lock the current line
logfile Log file configuration
mac-address MAC address information
mirroring-group Specify mirroring group
mld Multicast Listener Discovery (MLD) module
monitor System monitor
mpls Multiprotocol Label Switching (MPLS) module
mtrace Configure the multicast traceroute
mtu Specify Maximum Transmission Unit (MTU) of the interface
multicast Multicast module
no Alias for 'undo'
ntp-service Network Time Protocol (NTP) module
ospf OSPF module
ospfv3 OSPFv3 interface commands
packet-filter Packet filter settings
pim Protocol Independent Multicast (PIM) module
ping Ping function
port Specify a port
portal Portal authentication module
proxy-arp Specify proxy ARP function
proxy-nd ND proxy function
qos Quality of Service module
quit Exit from current command view
repeat Repeat executing history commands
reset Reset operation
return Exit to User View
rip Configure interface parameters for RIP
ripng Configure interface parameters for RIPng
save Save current configuration
security-logfile Security log file configuration
show Alias for 'display'
shutdown Shut down the interface
smartmc SmartMC module
sntp Simple Network Time Protocol (SNTP) module
tcp Specify TCP parameters of the interface
tracert Tracert function
traffic-statistic Specify traffic statistics configuration information
udp-helper UDP helper function
undo Cancel current setting
vrrp Virtual Router Redundancy Protocol (VRRP) module
web-redirect Web redirection function
write Alias for 'save'
[JLSH-HXJF-MES-S10506-02-Route-Aggregation100.4011]
(0)
最佳答案
交换机很多不支持,
具体可以看下手册,是否有相关命令,手册 :
https://www.h3c.com/cn/Service/Document_Software/Document_Center/Switches/Catalog/S10500/S10500X-G/Command/Command_Manual/H3C_S10500X_G_CR_R7760Pxx-25477/99/?CHID=1142269
(0)
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作
举报
×
侵犯我的权益
×
侵犯了我企业的权益
×
抄袭了我的内容
×
原文链接或出处
诽谤我
×
对根叔社区有害的内容
×
不规范转载
×
举报说明
暂无评论