LS-S5560X-30C-EI两台怎么配置堆叠

参考官方手册，链接：http://www.h3c.com/cn/d_201711/1046621_30005_0.htm#_Toc499550062

注意现场设备的版本号，最新的版本，已经不需要shutdown端口了，可根据具体的软件版本号选择手册

1，如果两台设备堆叠，首先设置从成员设备，也就是slave的编号为2，

 配置IRF中设备（原成员编号为1）的成员编号为2。

<Sysname> system-view

[Sysname] irf member 1 renumber 2

Renumbering the member ID may result in configuration change or loss. Continue?[Y/N]y

如果要取消以上配置，使设备的成员编号仍然是1，则可以执行以下命令：

[Sysname] undo irf member 1 renumber

Renumbering the member ID may result in configuration change or loss. Continue?[Y/N]y

2，将端口加入irf口了（该配置主从两台设备配置方式一样，不同的是，主设备irf端口号是irf-port 1/2，那么从设备就是irf-port 2/1，交叉互联），

<Sysname> system-view

[Sysname] interface ten-gigabitEthernet 1/0/49

[Sysname-Ten-GigabitEthernet1/0/49] shutdown

[Sysname-Ten-GigabitEthernet1/0/49] quit

[Sysname] irf-port 1/2

[Sysname-irf-port1/2] port group interface Ten-GigabitEthernet 1/0/49

You must perform the following tasks for a successful IRF setup:

Save the configuration after completing IRF configuration.

Execute the "irf-port-configuration active" command to activate the IRF ports.

[Sysname-irf-port1/2] quit

[Sysname] interface ten-gigabitEthernet 1/0/49

[Sysname-Ten-GigabitEthernet1/0/49] undo shutdown

[Sysname-Ten-GigabitEthernet1/0/49] quit

·     将当前配置保存到下次启动配置文件，以便IRF端口的配置在设备重启后能继续生效。

[Sysname] save

The current configuration will be written to the device. Are you sure? [Y/N]:y

Please input the file name(*.cfg)[flash:/startup.cfg]

(To leave the existing filename unchanged, press the enter key):

flash:/startup.cfg exists, overwrite? [Y/N]:y

Validating file. Please wait............................

Saved the current configuration to mainboard device successfully.

3， 激活IRF端口的配置。

[Sysname] irf-port-configuration active

备注，配置好irf之前，先不要连接堆叠线缆，配置好之后没问题了，保存过后再连接堆叠线缆