H3c-5040路由器与思科7606路由器用pos口互联问题

看看两端的j0j1字段对不对

我将j0和j1值更改乘一样依然有这个问题。
[H3C-Pos8/0]dis int pos 8/0
Pos8/0 current state: UP
Line protocol current state: DOWN
Description: Pos8/0 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10 (sec)
Internet Address is 192. 168. 100. 2/24 Primary
Link layer protocol is PPP
LCP reqsent
Physical layer is Packet Over SDH, Baudrate is 155520000 bps Scramble enabled, crc 32, clock slave, loopback not se
Output queue: (Urgent queuing: Size/Length/Discards) 0/100/0 output queue : (Protocol queuing : Size/Length/Discards) 0/500/0 Output queue: (FIFO queuing: Size/Length/Discards) 0/75/0 SDH alarm:
section layer: none
line layer: none
path
layer: none
2 (Rx): 0x16 c2 (Tx): 0x16
Rx: OJ: Оxсс
Тх: J0: OXCC
Rx: J1: "Router"
Тx: 11: "Router"
section laver: B1 0
Lineton layer: Bo 0 M1 PatrLayer: B3 0 010
Last clearineot contere ev
ast searing of counters: Never
seconds output rate 2 bytes/sec, 16 bits/sec, O packets/sed Input: 942 packets, 82428 byteslast 300 seconds input rate 3 bytes/sec, 24 bits/sec, 0 packets