无
某局点采用两台F5030 做IRF,发现配置完之后,IRF起不来,备机不自动重启,也无法加入IRF中,已激活IRF配置。查看配置并无发现异常,IRF port 两边配置的也没有问题,查看设备日志发现提示心跳超时。
%Dec 11 15:14:09:841 2019 H3C STM/2/STM_LINK_TIMEOUT: -COntext=1; IRF port 2 went down because the heartbeat timed out.
%Dec 11 15:14:09:841 2019 H3C STM/3/STM_LINK_DOWN: -COntext=1; IRF port 2 went down
首先检查IRF的相关配置,IRF port 配置都无问题,查看官网配置限制,并无匹配的限制
irf-port 1/2
port group interface GigabitEthernet1/0/0
irf-port 2/1
port group interface GigabitEthernet2/0/0
最后查看两个IRF的物理接口,发现接口下有CRC错误包,设备都已接地,并且也是直连的。
===============display interface===============
GigabitEthernet2/0/0
Current state: UP
IP packet frame type: Ethernet II, hardware address: 9429-2f90-5c74
Description: GigabitEthernet2/0/0 Interface
Bandwidth: 1000000 kbps
Loopback is not set
Media type is optical fiber, loopback not set, promiscuous mode not set
1000Mb/s, Full-duplex, link type is autonegotiation
Output flow-control is disabled, input flow-control is disabled
1000Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Maximum frame length: 9216
MDI type: Automdix
Last link flapping: 0 hours 27 minutes 30 seconds
Last clearing of counters: Never
Peak input rate: 0 bytes/sec, at 00-00-00 00:00:00
Peak output rate: 76 bytes/sec, at 2019-12-11 15:20:06
Last 300 second input: 0 packets/sec 0 bytes/sec 0%
Last 300 second output: 1 packets/sec 76 bytes/sec 0%
Input (total): 3375 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input (normal): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 3375 input errors, 0 runts, 0 giants, - throttles
3375 CRC, 0 frame, 0 overruns, 0 aborts
最终替换中间光纤,问题解决,IRF接口下一般不允许有错误包,如果有增长,就需要排查。
1. 需要确认设备是否接地,不接地也会有影响。
2. 确认光模块是否是原厂的。
3. 可以替换到其他接口,配置IP地址,然后测试连通性,确认接口下是否有错误包增长。
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作