设备型号:S10506-X
版本:E7633P01
现场两台10506X堆叠,重启备框进行故障演练,重启后发现两个25G口无法UP:2/0/0/21和2/0/0/22口
25G端口下使用10G光模块,查看端口收发光正常,但是接口无法up:
Twenty-FiveGigE2/0/0/21 transceiver diagnostic information:
Current diagnostic parameters:
Temp.(¡ラ Voltage(V) Bias(mA) RX power(dBm) TX power(dBm)
32 3.30 6.27 -2.42 -2.93
Alarm thresholds:
Temp.(¡ラ Voltage(V) Bias(mA) RX power(dBm) TX power(dBm)
High 81 3.80 16.50 1.00 1.00
Low 0 2.81 1.00 -11.90 -10.30
Twenty-FiveGigE2/0/0/21
Current state: DOWN
Line protocol state: DOWN(LAGG)
IP packet frame type: Ethernet II, hardware address: 98a9-2d17-5600
Description: Twenty-FiveGigE2/0/0/21 Interface
Bandwidth: 25000000 kbps
Loopback is not set
Media type is optical fiber, port hardware type is 10G_BASE_SR_SFP
将光模块重新插拔或端口做loopback自环均能up。
原因为 25G单板插入10G光模块时,在堆叠模式下启动时存在时序问题,导致部分插入10G光模块的端口跑在低速率时,由于PORT_COS_MAP资源申请失败,端口无法UP。 如果端口跑在25G速率则无问题。当前在R7596P10版本已经解决,方案组网建议升级至E7634P03版本解决。
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作