S7602-S-----------分光器---------ET354
设备上通过命令display interface Onu 查看对应端口有大量intput/output errors持续增长
Onu1/6/0/7:1
Current state: UP
IP packet frame type: Ethernet II, hardware address: 84d9-31e6-ac00
Description: Onu1/6/0/7:1 Interface
Maximum frame length: 1500
Loopback is not set
Port hardware type is Unknown
Broadcast max-ratio: 100%
Multicast max-ratio: 100%
Unicast max-ratio: 100%
PVID: 1
Port link-type: Access
Tagged VLANs: None
Untagged VLANs: 1
Last clearing of counters: Never
Last 300 seconds input: - packets/sec - bytes/sec -%
Last 300 seconds output: - packets/sec - bytes/sec -%
Input (total): 14366 packets, 2602938 bytes
100 unicasts, 0 broadcasts, 14266 multicasts, - pauses
Input (normal): - packets, - bytes
- unicasts, - broadcasts, - multicasts, - pauses
Input: 100 input errors, 0 runts, 100 giants, - throttles
0 CRC, - frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 10343 packets, 1961012 bytes
800 unicasts, 0 broadcasts, 9543 multicasts, - pauses
Output (normal): - packets, - bytes
- unicasts, - broadcasts, - multicasts, - pauses
Output: 700 output errors, - underruns, - buffer failures
0 aborts, - deferred, - collisions, - late collisions
- lost carrier, - no carrier
Input方向的 100 input errors 与接口Input方向的100 giants 增长速度和数量一致,经确认,ET354芯片有限制,会将大于1500Byte的报文识别成gints报文(gints代表超大帧,是指有效长度大于端口允许通过最大报文长度的帧),这样端口转发大于1500Byte的报文时intput/output会产生errors计数。实际小于2030Byte的报文端口都可以正常转发,该计数不影响业务。
芯片限制,硬件计数器就将 > 1500Byte 的报文作为 iant 报文,产生对应error计数,不影响转发。
该案例暂时没有网友评论
✖
案例意见反馈
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作