设备型号:H3C WAP722S-W2 内置天线双频四流802.11ac/n Wave 2无线接入点-FIT
ap做集中转发,想接ap上的网口供pc访问外网使用,ap应该怎么配置
(0)
最佳答案
进ap把端口隔离关掉,然后正常像配交换机一样就行
(0)
<882a-5e7b-95c0>display interface brief Brief information on interfaces in route mode: Link: ADM - administratively down; Stby - standby Protocol: (s) - spoofing Interface Link Protocol Primary IP Description InLoop0 UP UP(s) -- NULL0 UP UP(s) -- Vlan1 UP UP 172.16.10.9 Brief information on interfaces in bridge mode: Link: ADM - administratively down; Stby - standby Speed: (a) - auto Duplex: (a)/A - auto; H - half; F - full Type: A - access; T - trunk; H - hybrid Interface Link Speed Duplex Type PVID Description GE1/0/1 UP 1G(a) F(a) A 1 WLAN-Radio1/0/1 UP -- -- -- -- WLAN-Radio1/0/2 UP -- -- -- -- 这是ap上的接口信息,这个要配置吗
<882a-5e7b-95c0>display interface brief Brief information on interfaces in route mode: Link: ADM - administratively down; Stby - standby Protocol: (s) - spoofing Interface Link Protocol Primary IP Description InLoop0 UP UP(s) -- NULL0 UP UP(s) -- Vlan1 UP UP 172.16.10.9 Brief information on interfaces in bridge mode: Link: ADM - administratively down; Stby - standby Speed: (a) - auto Duplex: (a)/A - auto; H - half; F - full Type: A - access; T - trunk; H - hybrid Interface Link Speed Duplex Type PVID Description GE1/0/1 UP 1G(a) F(a) A 1 WLAN-Radio1/0/1 UP -- -- -- -- WLAN-Radio1/0/2 UP -- -- -- -- 这是ap上的接口信息,这个要配置吗
使用AP的GE1端口连接上行交换机或AC,GE2作为PC连接的有线网口(GE端口设置为access类型并放通业务vlan),注意对GE2做端口隔离,另外AP上需要放通业务vlan,且GE1口和对端交换机/AC的下行端口也要放通相关业务vlan。
(0)
您好,只要有口就可以
参考配置,其中100为PC的vlan,200为AP管理VLAN
vlan 100
vlan 200
quit
interface GigabitEthernet 1/0/1
port link-type trunk
port trunk permit vlan 100 200
port trunk pvid vlan 200
interface GigabitEthernet 1/0/2
port access vlan 100
(0)
亲~登录后才可以操作哦!
确定你的邮箱还未认证,请认证邮箱或绑定手机后进行当前操作
举报
×
侵犯我的权益
×
侵犯了我企业的权益
×
抄袭了我的内容
×
原文链接或出处
诽谤我
×
对根叔社区有害的内容
×
不规范转载
×
举报说明